Genie intellicode keypad reprogram how to#

Programming the Genie Garage Door Opener using the Intellicode I RemotesĪre you ready to learn how to program your Genie garage door opener remote? Once you have identified your remote type, it’s just a matter of following the step-by-step instructions outlined below. Alternatively, you can examine the operation buttons on the motor head to identify your remote type.

Genie intellicode keypad reprogram manual#

You may need to refer to your owner’s manual to determine which one you have. To become an expert in programming your Genie garage door opener, you must first identify which type of remote you possess. Once the light goes out you must enter the 4 digit code again.Genie has created three different remote types for its various garage door openers. When the door closes you can re-open it while the light is still on in the keypad by pressing any key. Note: while the opener is working you can touch any key on the keypad to stop/reverse it. Enter desired 4 digit code on the keypad.

To program the following is the easy procedure Just open the small rectangular plastic plate on the panel where the battery is located, move switch to 'program'. It is very easy while working with the panel to accidentally push the large button on the panel and operate the door opener! The door might strike you or someone else. The reason to unplug the opener is probably a safety concern. What is being programmed is the circuit board in that panel NOT the opener as is done with wireless remotes for your cars or wireless keypads. In fact, if you unplug the battery the circuit board in the panel has no power and cannot be programmed. Make sure you have a fresh battery! There should be no need to disconnect the battery or unplug the opener.

When the battery dies the code is lost and needs to be reset. Have had it for 25 years since it came with a 1994 Craftsman opener. The Keypad is wired to the indoor panel and the panel is wired in turn to the opener. I have the same keypad outside the garage and a panel with large rectangular pushbutton inside. The button pad that the keypad is wired to does have a PROGRAM/OPERATE switch under the nameplate. Should I instead have remove the battery at this point? So when it said to unplug the opener from the electrical outlet, I instead removed the wires from the button pad opener to the actual opener in the garage ceiling. I followed this, although the button pad is wired with a battery. Slide the switch back to operate and plug the garage door opener back in. Next, enter your desired four-digit PIN number into the keypad. Next, remove the nameplate from the console that the keypad plugs into and locate the program/operate switch. 'Is this a hard wired keypad? If so: To program the keypad, first unplug the garage door opener from the electrical outlet. The best instructions I found for a keypad without an enter key say this: The keypad is wired to a button pad just on the inside of the door. The keypad does NOT have an ENTER key, but it has '*' and '#' buttons, in addition to the 0-9 numbers. The keypad itself is Liftmaster, but the unit itself and wired openers (the button pads to open/close it) are Sears craftsman model 139.53425SRT. No problems with this until recently the external keypad stopped working. We moved into this house about 15 months ago.